Back

All the trim work on the exterior of this house was done by Tetreault Custom Carpentry. The fascia boards, the front entry and all the window trim was made from azek.

This is the front entry with lots of raised panels to match the door layout and window arch.

All the corner boards were all made with azek too, twenty foot corner boards! The front of the house has smaller raised panel corner boards to match, also made out of azek.

Everyone has a different idea and that's what we like. The round columns are a pre-cast column and we didn't do much to them but help put them in ( very heavy). The trim around the front entry consists fluted columns from the deck to the 3/4'' tongue and groove ceiling. Between the fluted columns are recessed panels following the door to window pattern.

The aluminum columns on the left are strong enough to carry the weight of this roof top. Our trim helps with the esthetics of the columns. The picture below are the columns we built in our workshop out of azek. They span almost twenty feet. The tops and bases have raised panels on all four sides. The center is fluted also on all four sides.